I have a bunch I can sell you

 

PM sent! Thanks for the reply Gordon.

Mike

 

You can buy them directly from QA-1 as well.

 

So I would be looking at the HMR10-12 for $32 each? Thanks for the link

Mike

 

That looks right to me, or the $36 HMR10-12T (teflon lined for lubrication). I'd just double check your dimensions - the part number you referenced in the first post looks like a McMaster part number that has a 3/4" through hole.

 

Right in CT:
FK Rod Ends- Home Page

 

A quality bearing is expensive, $30-40 each. For the rear expect to pay around $300 just for the bearings. Don't cheap out here. Buy from a reliable guy like Gordon and be done with it.

Replace the lock nuts and dust covers at the same time. Don't be tempted to re-use the old ones.

 

I agree w/ Bob but will say I usually back off the most expensive by a notch. In general you want 3 piece teflon or ptfe lined and all steel construction. Once you have the exact size google it and many sources will appear. I have bought quite a few from Summit. This is another source for the high end stuff.
https://secure.chassisshop.com/default.aspx?serverid=TCS
I did a 2015 IRS upgrade last winter and used the ones FFR supplied. I don't know what they are but they seem to be good quality so they would be a great no research needed source.