I am trying to have my sniper efi to control the cooling fan. I took the light blue output wire that says it’s for the fan from the sniper and spliced into the green wire on the fan relay. Then I adjusted the setting in the handheld to around 30 degrees for the fan on/off to test. The fan just continues to run. As it would without the sniper. Anyone accomplish this would be so kind to share how they wired it? The RF manual says two different things depending on the pdf and the book. One says cut the blue wire the other says cut the red jumper.
![Image]()
HoustonCobra
Sniper efi to control cooling fan
I am trying to have my sniper efi to control the cooling fan. I took the light blue output wire that says it’s for the fan from the sniper and spliced into the green wire on the fan relay. Then I adjusted the setting in the handheld to around 30 degrees for the fan on/off to test. The fan just continues to run. As it would without the sniper. Anyone accomplish this would be so kind to share how they wired it? The RF manual says two different things depending on the pdf and the book. One says cut the blue wire the other says cut the red jumper.
![Image]()
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
