Factory Five Racing Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
64 Posts
Discussion Starter #1
I'm getting very close but the headlight wiring is holding me up. I'm using the stock '93 mustang harness (prepared by Rob W.), turn signal from Richard O. with the VW relay. I cannot get the high beams to work with the turn signal button. Also the front running light and right rear running light are very bright and you can't tell when turn signal on. I'm attmpting to us a toggle for the headlights. Thoughts?
Thanks, Tim G
 

·
Vendor
Joined
·
8,397 Posts
Give me a call and I'll walk you through the checks. It sounds like the brake light filament is being runn off the running light wire in the rear. Try swapping the brake and running light leads at the light itself.
760-403-6266
 

·
THRAMP-master
Joined
·
3,473 Posts
On the bright running lights, you may have the wires switched - which means the "running" hot wire is feeding the "turn" filament of the bulb.
 
1 - 3 of 3 Posts
Top