Where did the MSD Coil go??

303 Views 7 Replies 6 Participants Last post by 1686, Nov 6, 2002

oldsnake

Discussion Starter · Nov 6, 2002

If you mounted your MSD 6A or 6AL ignition box on the passenger side behind the dash, Where did you mount the coil? The wires from the box aren't long enough to let you mount it on the inside of the "F" panel, and if you mount it close to the box, the coil wire is half a mile long? Just trolling for preferences here...thanks..

Save

1 - 1 of 8 Posts

1686

· #8 · Nov 6, 2002

I have the Blaster3. I mounted it on the driver side f-panel. FMS 9mm coil wire reaches fine. I did have to extend the wires from the 6AL, though. I ran them behind the dash and out with the harness going to the front that comes out of the driver footbox.

Hope this helps, Brian

Save

1 - 1 of 8 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.