Factory Five Racing Forum banner
1 - 9 of 9 Posts

·
Runs with scissors!
Joined
·
562 Posts
Discussion Starter · #1 ·
I got the tubular LCA's from FFR, installed them weeks ago and never noticed until last night that neither of them have a grease zirk for the ball joint. The hole is there (the grease on the floor is what alerted me) but the zirks are not.

I looked through the inventory sheet and don't see them listed as a separate item. I looked through my remaining hardware anyway, and didn't see them. Does anyone know if they are packed separately, and if so - where? Or do I just need to stop at NAPA on the way home?
 

·
Senior Member
Joined
·
4,342 Posts
My zircs and cotter pins were in a bag in the box with the LCAs and ball joints.
 

·
Runs with scissors!
Joined
·
562 Posts
Discussion Starter · #4 ·
Thanks, guys, I'll do some more searching. My LCA castle nuts/cotter pins were backordered so it could be that I just never got em? But I'll look again. Not a huge deal.
 

·
Runs with scissors!
Joined
·
562 Posts
Discussion Starter · #8 ·
I searched and searched and never found them, guess I'm headed to NAPA on the way home.

Does anyone know off hand what thread size I'll need? Otherwise I'll just grab a selection, they can't be that expensive.
 
1 - 9 of 9 Posts
Top