Factory Five Racing Forum banner

Status
Not open for further replies.
1 - 7 of 7 Posts

·
FFCobra Fanatic
Joined
·
616 Posts
Discussion Starter #1
I have the 17x9 Steeda's and they fit.
I've been told the 2000 Cobra R's will fit.

I'm going over Richard Oben's to test fit the older Cobra R's this week.

Anybody else know for sure, for sure, other wheels that fit?
 

·
FFCobra Craftsman
Joined
·
1,333 Posts
The Compomotive Halibrand replicas should clear - I have seen 2 cars with these wheels and Dynalite calipers (s/b the same width as the Superlites) that did (using SN95 spindles).

I hope so, as I have a set on order!
 

·
Registered
Joined
·
1,820 Posts
The superlites are wider than the dynalites. Below are the widths from the website:

dynalite - 1.67"
superlite 4 - 2.14"
superlite 6 - 2.35"

craig
 

·
Pro FFR Builder and Moderator
Joined
·
14,685 Posts
The 6 piston calipers are thicker than the superlights.
Cobra R's fit
ROH R/T's fit
ROH snyper with spacer with fit
The Steeda's should fit
 

·
FFCobra Craftsman
Joined
·
1,333 Posts
Gordon - I believe I saw a red Cobra in your shop with the 6-piston Superlites and what looked to be Compomotives. Did you have spacers on that car?
 

·
Super Moderator
Joined
·
29,434 Posts
Centerlines DON'T fit.

2FAST (and quickly going broke!)
 

·
Pro FFR Builder and Moderator
Joined
·
14,685 Posts
Barry, Those were ROh R/T's. I don't use compomotives.
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top