Factory Five Racing Forum banner
1 - 5 of 5 Posts

· Senior Charter Member
1,479 Posts
Discussion Starter · #1 ·
My car is in the rolling chassis stage and the body is off the car. Can I install the underdoor aluminum panels now or do I need to wait until the body is fitted?

It'd sure be nice if I can mount the two panels now while everthing is easily accessible.


Jim Doak
FFR 2117

· Senior Member
1,018 Posts
Better to wait till body is fitted.


· Registered
322 Posts
Mine went this way:

*Fit Body
*Fit under door aluminum to fit body. Drill a few holes and clecoe in place
*Remove under door aluminum and body
*Replace under door aluminum and finish drilling and trimming
*Rivet under door aluminum
*Paint body
*Install Body.
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.