Factory Five Racing Forum banner
1 - 3 of 3 Posts

·
Junior Charter Member
Joined
·
148 Posts
Discussion Starter · #1 ·
Hi all,

I am sure some of you could provide this information to me:

1.) I have a '95 mustang motor and tranny combo. Can someone show me a picture of the grinding that needs to take place on the tranny bellousing, etc.? A picture would really help.


2.) Can someone provide me with a measurement from the firewall to the head and valve cover on the pass. side of the motor. I think I placed my vintage air blower to close to the center of the car/ motor compartment. Any clear photos would greatly help (with a tape measure shown).

Cheers...!

Matt
 

·
2010 FFCars Graduate
Joined
·
3,032 Posts
I don't think you have to grind a stock bellhousing.
I didn't.
This is probably the best pic I have of my heater installed. No tape measure but it might help.
If you mounted it according to the instructions yours should look like mine.
 

·
Junior Charter Member
Joined
·
148 Posts
Discussion Starter · #3 ·
Humm... Looks like I have to do some re-working. Thanks
 
1 - 3 of 3 Posts
Top