Factory Five Racing Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
I am installing my trunk hinges, but I have two small peices of aluminum angle that I don't know what to do with. These are in addition to the metal "L" brackets that are in the hardware kit.
Thanks -- Joey H
 

·
Charter Member
Joined
·
423 Posts
The brackets are for the trunk,at least thats how my kit came. Install them after the arched aluminum trunk piece is installed. They attach to the trunk hinge with one nut (short leg). The long leg runs down to the trunk cross brace, drill through the cross brace and bracket, and bolt them together. The bracket goes on the back side of the brace, they may need trimmed at the bottom. These also add support to that area of the body.

Ron
 

·
Premium Member
Joined
·
7,237 Posts
Mike's right. The aluminum angles are for the hood latches. The longer steel pieces are for what Ron is describing.
 

·
Charter Member
Joined
·
423 Posts
Sorry, I didn't read the post close enough. Yup little aluminum angles for the hood, bent steel for the trunk!

Ron
 
1 - 7 of 7 Posts
Top