Factory Five Racing Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
387 Posts
Discussion Starter #1
Does anyone have noticed an asymmetric design on the back of the Trigo wheels?
Precisely, the paint on the back part of the wheel and the center section are not symmetric but all wheels seem to be balanced!
Any explanation?
Thx
Cyril
 

·
We don't need no stinkin stitches
Joined
·
1,432 Posts
CBP,
I noticed the same thing. I think it is that the casting tolerances are far larger than the machining tolerances. Therefore you see the seemingly non true apperarance.
I asked the guy that mounted my tires to check the wheels before mounting the tires. They were all dead nuts on for balance, and true axially and radially. They were impressed and so was I.
All weights added were minimal, and only for tire imbalance. They did however mount three of four tires 3-4 times to get min weight requirement.
Jack
 

·
Registered
Joined
·
387 Posts
Discussion Starter #3
Thx Jack.
This morning we tried to balance one wheel and it was not good! :-(
Any other feedback or same experience?
I am still waiting a feedback frome Trigo.
Thx
Cyril
 
1 - 3 of 3 Posts
Top