Factory Five Racing Forum banner
1 - 1 of 1 Posts

Junior Charter Member
239 Posts
Brake failure

I had the same thing happen to me last year. Rear PS. I made a hard rubber bump stop and attached it to the bottom of the frame making sure the brake line cleared the pad on full compression. The pad is just a little thicker than the brake line. I also sent the rear Bilstein shocks to their repair facility for the upgrade ( I had the fronts done in '09 ). 600lb springs were also installed in the rear. Stock 450lb were retained in front. Handling is greatly improved and no brake worries.
Problem solved, problem staying solved.

Good luck: Krusty
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.