Factory Five Racing Forum banner
1 - 2 of 2 Posts

·
Senior Charter Member
Joined
·
1,521 Posts
Discussion Starter · #1 ·
I just purchased a stock 90 degree thermostat housing (this one even has a plug for a sensor) to replace the POS Chrome FRP unit that leaks. I would like to use standard bolts as opposed to the socket heads that came with the FRP unit. What size are these, and should I get standard zinc or stainless? The unit is a beefy cast unit, so stainless would look out of place (or so I think).

Tom
 

·
Senior Charter Member
Joined
·
1,521 Posts
Discussion Starter · #2 ·
TTT
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top