Factory Five Racing Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Banned
Joined
·
5,303 Posts
Discussion Starter #1
can i change the size of the spacers a little bit? i need only a mm or two. ive got the stang lowers, and it looks like the FFR tubular lowers allow more room for spacing.

my question is: how much can i change the spacers on the top connection before the stresses are bad for the mounts?

thanks,

-james
 

·
Registered
Joined
·
3,154 Posts
James,

I changed to the new front uppers the other day on 1225. The spring was too close so I reversed the spacers. I think it went from the small one forward to the larger one forward.

Roger
 

·
Banned
Joined
·
5,303 Posts
Discussion Starter #3
roger, thats crossed my mind, but now the stress on the upper mount is created at an angle... (which i assume in the reason the spacers were offset to begin with- to position the spring parallel to the frame mounts)

-james
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top