Factory Five Racing Forum banner
1 - 4 of 4 Posts

·
Charter Member
Joined
·
122 Posts
Discussion Starter · #1 ·
I am converting my e-brake to a Fiero handle and I need to shorten the drivers side cable sheath.
How about some help here. Do you try to remove the end fitting or just cut a section out and butt it back together with a rubber hose clamped over the outside? Any other thoughts? Thanks In advance, as always.
Bob
 

·
Charter Member
Joined
·
122 Posts
Discussion Starter · #2 ·
TTT... Anybody?
 

·
Charter Member
Joined
·
122 Posts
Discussion Starter · #7 ·
I have Mark VII rear calipers and Mark VII cables. I need to shorten the drivers side significantly. The caliper end is a little unique. The front end is the same as any Ford cable. Can I get new swage front end fittings? Do you know of a source?
Thanks for all the info, I do appreciate it.
Bob
 

·
Charter Member
Joined
·
122 Posts
Discussion Starter · #8 ·
Sorry, double post.
Bob
 
1 - 4 of 4 Posts
Top