Factory Five Racing Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
869 Posts
Discussion Starter · #1 ·
I did a great job of scratching the black shaft part of the switch while fishing it through a panel. Does anyone have any ideas on how to either fix the scratches or put some type of polished cover over the black part of the switch?
 

·
Charter Member
Joined
·
2,649 Posts
I could be talking way off line but I would think you could take some very fine sand paper to the deep grooves and then put some Armoral or similar vinyl product to try and bring out the black shine. Try a small spot on the bottom side of the switch to try it out.
Bob Mac
FFR3981
 
1 - 2 of 2 Posts
Top