Factory Five Racing Forum banner
1 - 3 of 3 Posts

·
Junior Charter Member
Joined
·
32 Posts
Discussion Starter · #1 ·
Hey guys, trying to finish up 3 link installation and I am unsure about how the LCA bushing is aligning with the tabs on the frame. Should I just tighten it up or should I try to correct it? Pics below, any help on this topic much appreciated. - Kevin


Rear LCA, drive side, forward. Right side is not parallel with bushing.


Rear LCA, drive side, forward. Left side seems to be parallel with the bushing.


[ June 09, 2007, 08:42 AM: Message edited by: Kevin K ]
 

·
Junior Charter Member
Joined
·
382 Posts
I looked under car and looks like I put one washer on outside driver side.

Frank
 
1 - 3 of 3 Posts
Top