Never heard of any that you dont just push thru and rotate a .25 turn.
later
AFTER THINKING FOR A COUPLE OF MINUTES....
Most/Some push thru from the back, thru the hole in the shoe, and then you put a slotted sheet metal washer on from the front, with the spring under that washer. so, the hole in the backing plate would be round....
earl
[ October 26, 2002, 03:15 PM: Message edited by: CobraEarl ]
later
AFTER THINKING FOR A COUPLE OF MINUTES....
Most/Some push thru from the back, thru the hole in the shoe, and then you put a slotted sheet metal washer on from the front, with the spring under that washer. so, the hole in the backing plate would be round....
earl
[ October 26, 2002, 03:15 PM: Message edited by: CobraEarl ]
