Factory Five Racing Forum banner
1 - 1 of 1 Posts

·
Administrator
Joined
·
9,547 Posts
You will need to cut the passenage side upper mount off. You need to make sure the new upper control arm is installed at a 90 degree angle to the axle. To do this, you will need to remove the old mount. I cut a hole in the aluminum behind the seat to access the old mount and cut it out.

Good luck.

Bill
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top