Factory Five Racing Forum banner
1 - 2 of 2 Posts

·
FFCobra Fanatic
Joined
·
3,878 Posts
Discussion Starter · #1 ·
It looks like the teeth are flatter on the gear shaft compared to the pinion. Any ideas ? The gears are Ford 3.27, 8.8 and the flange is ford racing and I have the original flange. Both do not fit.
 

·
FFCobra Fanatic
Joined
·
5,560 Posts
Hey Bill,
I just tried one down in the basement and it fits just fine. I dont know if the 7.5 pinion flanges are different than the 8.8 ones but its the only thing I can think. Mine goes on in different spots so its not indexed or anything. Sometimes they have a key so it only goes on one way but not this one. Maybe try measuring the ID and OD of the two pieces for verification. I got about 1.310" ID across my flange which is definitely an 8.8 one.

Mike
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top