Factory Five Racing Forum banner
1 - 11 of 11 Posts

·
FFR 4331
Joined
·
1,114 Posts
Discussion Starter · #1 ·
Can I please see some close up shots of the badges and side vents? I am trying to figure out the spacing.

I have the ERA specs that everyone uses as a guide but a test fit per those specs looked "funny".

I am talking about the rectangular 427/351/Powered by Ford badges BTW.

Thanks!
 

·
Premium Member
Joined
·
18,585 Posts

·
Registered
Joined
·
554 Posts
There should have been 2 dimples in the body above each vent. These can be used for drilling the badge post holes?
 

·
FFR 4331
Joined
·
1,114 Posts
Discussion Starter · #6 ·
Thanks guys! Ace - two Rolls Royce blue in the same state (you and LNJ). Must be quite a sight.

BTW - NAGA, I'll let the pics through my filter. Thanks loads!
 

·
I built it myself
Joined
·
641 Posts
Here's a picture of FFR4627K's side badge and louvers. Hope this helps, Rick
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top