Factory Five Racing Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
3,676 Posts
Discussion Starter · #1 ·
I am rebuilding a T-5 as an eventual replacement. It was to go in with the new engine, but I will not get than done for spring. I want to prep the new transmission to go asa trans swap, just in case I need it this summer.

There have been some threads about trimming certian tabs off the T5 to make it easier to install without pulling the engine. Looking at the case I think I have it right but not sure I have all.

Anybody have a picture or two

Thanks
 

·
Senior Charter Member
Joined
·
887 Posts
I too would like to see some photo's of the tabs to trim... I am getting close to that point. Thanks

CalHusker
 

·
Premium Member
Joined
·
3,110 Posts

·
Registered
Joined
·
3,676 Posts
Discussion Starter · #4 ·
Thanks Steve - that was the thread I could not find
I have to remeber to search T5Z as well as T5 and T-5


 
1 - 4 of 4 Posts
Top