Factory Five Racing Forum banner
1 - 4 of 4 Posts

·
Senior Member
Joined
·
7,906 Posts
Discussion Starter · #1 ·
I have a set of 4 PS engineering spinners and anew set of o-rings for sale. Make an offer.

Also I am considering parting with a set of Replica Cobra R wheels made by speedware. they are 17 4 lug x 9.5 I believe. The have almost new Khumo tires on them I will not shp these wheels local pickup only.

I also have a set of calipers and rotors froma t-bird 8.8 that I took off my car to do a 5 lug upgrade. They work well but are not new.

Front 4 lug rotors used but never turned.

Brand new Cobra Upper manifold. I have a lower too but it is missing the tapped hole for the Air charge temp sending unit. NOt sure why its not there but can be drilled.

Thanks Mike
 

·
Registered
Joined
·
3,408 Posts
FYI you don't need to drill for the ACT sensor in the #5 runner if you don't want to. Simply extend the harness and put the ACT sensor in the side of the air intake elbow, or anyplace in the incomming air stream ahead of the throttle body. It's been done before, it works, and it's easier to do than drill and tap the #5 runner.
 
1 - 4 of 4 Posts
Top