Painless wiring - headlights (separating fact from fiction)
I have heard many opinions on the painless harness concerning the headlight circuits. I have heard that you should upgrade to 10 gauge wire. I have heard that you should use a relay. I have heard that you should do both of these. What have you guys been doing?
If I put in relays, what size? The same for low beam and high beam? What gauge wire does it really require?
I would assume that Painless knows what they are doing...but assumptions can be bad? Are there any other shortcomings of the harness I should know about?
[ September 06, 2002, 05:25 PM: Message edited by: rlogan ]
If I put in relays, what size? The same for low beam and high beam? What gauge wire does it really require?
I would assume that Painless knows what they are doing...but assumptions can be bad? Are there any other shortcomings of the harness I should know about?
[ September 06, 2002, 05:25 PM: Message edited by: rlogan ]
1 - 1 of 6 Posts
1 - 1 of 6 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Factory Five Racing Forum
A forum community dedicated to Factory Five owners and enthusiasts. Come join the discussion about performance, racing, conversions, modifications, troubleshooting and drivetrain. We discuss MK4, GTM, 818, Type 65 coupe, roadsters, and more!
Full Forum Listing
Recommended Communities
