Factory Five Racing Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
735 Posts
Discussion Starter · #1 ·
The assembly of my new lift is going ok, but has been interrupted a few times for trips to Homer to replace missing hardware. My question for anyone with one of these lifts is this - what's the red lever for that mounts between the motor and the reservoir? Mine is loose and free spinning with 2 jam nuts locked onto the shaft.

Thanks,

Tom
 

·
Registered
Joined
·
63 Posts
Tom, I had that same question with my lift...
turns out that you pull OUT on the red handle to let the lift down. I discovered this by trial and error while trying to figure out how it worked!

Good Luck,
Jack
FFR2833
 

·
Registered
Joined
·
735 Posts
Discussion Starter · #3 ·
Wow, I didn't expect that answer, but it makes sense. Thanks Jack. Tomorrow's the day I finally get the Cobra out of harms way, away from rakes, shovels, bikes and neighborhood kids playing hide and seek!

Later,

Tom
 
1 - 3 of 3 Posts
Top