Factory Five Racing Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
FFCobra Master Craftsman
Joined
·
1,941 Posts
Discussion Starter · #1 ·
I have the Breeze upper steering shaft, the FFR spec racer lower shaft, and the Flaming River ujoint and rack. What holds these three sections together? The upper shaft slides into the lower shaft, which slides over the upper shaft from the Flaming River ujoint, but I don't see any way to bolt or fasten them. Are they just free floating, held in place by the collars at the bearing blocks? Thanks in advance for any info...

Ed Reynolds
FFR3619 :rolleyes:
 

·
FFCobra Master Craftsman
Joined
·
1,941 Posts
Discussion Starter · #3 ·
Thanks for the quick response. The FFR spec racer lower shaft doesn't have any clips like the stock setup. What stops the steering wheel from pulling the upper shaft out? Just the bearing collar?

Ed Reynolds
 

·
FFCobra Master Craftsman
Joined
·
1,941 Posts
Discussion Starter · #5 ·
Sot, the upper collar stops the upper shaft from pulling out, but what stops it from sliding in? Does it slide in flush with the dash? Sorry for all the questions, I just don't want to make a mistake in this area!

Ed Reynolds
FFR3619
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top