Factory Five Racing Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
332 Posts
Discussion Starter · #1 ·
As suggested by numerous people on this Forum I am planning to use the Neutral safety switch between the ignition and the relay as a fail safe. Should I just cut off the connector that is currently on the switch and hard wire it in or do I need the other end of the connector?

Murph
 

·
Registered
Joined
·
332 Posts
Discussion Starter · #4 ·
If I use the clutch safety switch do I need to do anything to the neutral switch pigtail coming out of the trans or does it already have a jumper?

Murph
 

·
Registered
Joined
·
332 Posts
Discussion Starter · #6 ·
I've got a carb setup with American Autowire harness. As I understand it you wire the neutral safety switch (or clutch safety switch in line with the wire running from the ignition to the relay - it is not getting the full current of the starter motor.

Murph
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top