Factory Five Racing Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
964 Posts
Discussion Starter · #1 ·
Im looking for a driveshaft shop that can cut down and balance a strange chromemolly driveshaft. was going to use s.s. bearing but was warned not to.
the car is making 1200 hp and sees highway use so it needs to be done correct.
any sugestions?
 

·
ff cobra master craftsman
Joined
·
2,784 Posts
We use cockcroft co for our race car driveshafts they are located on 33 waterman ave East Providence, RI phone 401-438-3650. I used them this spring to lengthen my drive shaft when I converted to a big block.
 

·
FFCobra Master Craftsman
Joined
·
2,078 Posts
I used Cockroft in E. Providence as well.
Doug
 

·
Registered
Joined
·
1,728 Posts
I just had a driveshaft shortened and balanced at Cockroft last week. Great service, they had it done the day after I dropped it off.

Charlie
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top