Factory Five Racing Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
922 Posts
Discussion Starter · #1 ·
MKIII
Street performer seats
Breeze brackets

I'm considering cutting the frame support that the left rear of the drivers seat hits (the one that attaches near the door latch) and replacing it with 2 flat steel supports. This would allow the seat to be more straight without hacking up the seat frame.

Need opinions...

Also, the aluminum corner goes on the outside of the support, right?

Ron

[ November 30, 2004, 07:07 PM: Message edited by: Ron5150 ]
 

·
Charter Member
Joined
·
2,649 Posts
Ron, email me tomorrow at work so I don't forget
[email protected]
I'll email you pictures and discription on how I installed the Breeze mounts and sliders (drivwre side)with out taking apart the seats, and keeping them straight in the cockpit, does require a few blows with the BGF if that's acceptable to you..
Bob Mac
FFR3981
 

·
Registered
Joined
·
922 Posts
Discussion Starter · #4 ·
The part that you squeeze is connected to the frame of the seat where the seat belt goes through and my ass barely fits in there now ( I'm 6'0" and 175). I don't know how people fit in these things.
 

·
Senior Member
Joined
·
15,282 Posts
I'm using SP seats. I wouldn't modify the frame for them, that's for sure. Find a different seat instead. There was a post here a week or so ago about a guy that thinks he's got Porsche seats to fit. How tempting that is...

Cheers, John
 
1 - 5 of 5 Posts
Top