Factory Five Racing Forum banner
1 - 9 of 9 Posts

·
Registered
Joined
·
1,136 Posts
Discussion Starter · #1 ·
I ordered the complete kit with the 4.6 kit which came with the oil pan. At first rik at ffr todl me thy had the bolts that fit under the flange where the standard bolts dont fit. I just spoek to a new guy there and he said that they dont sell them. So can someone lead me in the right direction on where to get them. Im a little fustrated. They have the oil pan in the kit but not the bolts. Thats retarded.
 

·
Registered
Joined
·
225 Posts
Canton studs

I used a stud kit (22-364) from Canton Racing Products. They hold the gasket in place, fit under the bump out and the make the job easier than bolts.

-Mark
 

·
Registered
Joined
·
167 Posts
X2 on the stud kit. Makes it a whole lot easier.
 

·
Registered
Joined
·
191 Posts
oil pan bolts

Strange ! There were on my packing list too but not in the box, so I called Rick at FFR and he sent me some.
 

·
Registered
Joined
·
779 Posts
X2 on the stud kit. Makes it a whole lot easier.
x3 on the studs; Much easier to install and remove - which I've done a time or two since the initial install. And seems like they were only about $10 for the kit.
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top