Factory Five Racing Forum banner
1 - 7 of 7 Posts

·
FFCobra Fanatic
Joined
·
5,543 Posts
Discussion Starter · #1 ·
Anybody not using the aluminum plate to cover the shifter hole? I am going to the midshift location and could use the plate the FFR supplies to block off the old hole. I know I could make one but if someone doesnt mind shipping one out, it would be much appreciated.... Thanks guys!

Mike
[email protected]
 

·
FFCobra Fanatic
Joined
·
5,543 Posts
Discussion Starter · #4 ·
Thanks Charlie...PM sent!!!

Mike
 

·
FFCobra Fanatic
Joined
·
5,543 Posts
Discussion Starter · #6 ·
Hey yours should be in your kit...I thought you took inventory. What gives?

Mike
 

·
Charter Member
Joined
·
1,776 Posts
I just cut one out of some extra aluminum. Measure the existing hole, add a 1/4" or so, and use a compass to trace the circle. Then used a jigsaw to cut it out and riveted it on.
Raul
 
1 - 7 of 7 Posts
Top