Factory Five Racing Forum banner
1 - 3 of 3 Posts

·
FFCobra Master Craftsman
Joined
·
1,500 Posts
Discussion Starter · #1 ·
hi guys

looking to set up my shaft and steering wheel. Can a few guys measure from the back of the steering wheel to the front side of the frame just below the pillow block? I would just like a ball park number to roughly set this up. I know I can put it wherever I want but I want it to look correct.

thanks
 

·
Moderator
Joined
·
3,875 Posts
From the face of the frame crossmember that the upper pillowblock for the stearing shaft is mounted on it's 6" to the face of the dash and from the face of the dash to the stearing wheel is another 3-1/2". So to answer your question, it's 9-1/2".
Here is a photo of the finished roadster, the turn signal setup is from Russ Thompson.

Don
 
1 - 3 of 3 Posts
Top