Ever since I installed my McLeod scatter shield and new tranny, I've had a mysterious oil leak. While I was in doing the tranny, I also replaced the rear main seal and the pilot bearing.
After the upgrade I started seeing oil on the bottom of the bell housing and the floor. I thought I might have goofed up the rear main, so I had another one put in. It still leaks. I am now seeing oil on the outside of the scatter shield even on the top. Seems like the oil is coming from elsewhere. I looked at the base of the intake and the valve covers (best I can with the engine in the car), but don't see any leaks there.
Are there any bolts that hold on the scatter shield which go into an oil resevoir? Perhaps I missed one.
With my Mcleod shield and the Canton T type pan the shield and pan were very close! The lip on the pan had to be bent a tiny bit to clear. I would check your front of the pan clearance.
This is an older thread, you may not receive a response, and could
be reviving an old thread. Please consider creating a new thread.
Factory Five Racing Forum
A forum community dedicated to Factory Five owners and enthusiasts. Come join the discussion about performance, racing, conversions, modifications, troubleshooting and drivetrain. We discuss MK4, GTM, 818, Type 65 coupe, roadsters, and more!