Factory Five Racing Forum banner
1 - 1 of 1 Posts

Senior Charter Member
2,837 Posts
You have to notch the bracket as shown below. BTW, the thread size is metric, M5-.80 x16 (the length will have to be ground down)

I picked up a couple from Lowes, but they aren't stainless steel. McMaster has them, p/n: 90258A251, but I didn't feel like spending $12 on 50 screws that I only need 2 of. Too bad Finish Line doesn't supply these as part of the bracket (hint hint).

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.