Factory Five Racing Forum banner
1 - 4 of 4 Posts

·
Charter Member
Joined
·
3,487 Posts
Discussion Starter · #1 ·
I'm attempting to mount my ps engineering wheels the wheel studs seem to be 1/4" too long for the closed end, 1/2 shank nut supplied. Seems that I could cut off the wheel studs to make if fit but seems like a fair amount of effort. What do you think? The other alternative would be to go with open end 1/2 shank but that's not going to look as good.
 

·
Charter Member
Joined
·
3,487 Posts
Discussion Starter · #4 ·
Bobyou are right on the money. I took my sawsall and file to them lastnight. They are on now and look great.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top