Factory Five Racing Forum banner
Cancel

Mounting EGR

269 Views 4 Replies 3 Participants Last post by  teamfour, 
F
Does the EGR valve need to be mounted in the original orientation? (i.e. against verticle wall mounted upright) If I cut it out on a mass air converted desmogged 5.0 what size resister to I place in line? Any down side to cutting it out?
Thjanks
Bill
Reply
Save
Like
1 - 1 of 5 Posts
Robert Duncan
Lee,
Are you referring to the TAB/TAD solenoids? As far as I know, the EGR valve can not be simulated with resistors.

Bill,
I have the valve striped down to just the sensor coil with the pin sticking out. The pin is half depressed and taped/tie wrapped to the wire bundle behind the engine.
Reply
Save
Like
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Factory Five Racing Forum
A forum community dedicated to Factory Five owners and enthusiasts. Come join the discussion about performance, racing, conversions, modifications, troubleshooting and drivetrain. We discuss MK4, GTM, 818, Type 65 coupe, roadsters, and more!
Full Forum Listing
Explore Our Forums
Factory Five Roadsters 2006 Roadster Archives - Read Only FFR Type 65 Coupe Factory Five GTM Forum Parts For Sale / Wanted
Top