Factory Five Racing Forum banner
1 - 8 of 8 Posts

·
Senior Charter Member
Joined
·
3,848 Posts
Discussion Starter · #1 ·
Folks, I do have what appears to be the fasteners to hold the fuel line in place. They are the black plastic covered piece that gets screwed into the frame. Problem is they seem a bit to big. Now, the brake lines would seem to have the same type fastener but of a smaller diameter? I don't seem to have any other package? Did anyone just go buy something better? Let me know........thanks!
 

·
Premium Member
Joined
·
18,585 Posts
Kobrak,
You should have several different sizes in your kit. We call them P-Clamps in the aircraft industry because they look like the letter P. You can get them in lots of different sizes at your local Ace Hardware.

d



 

·
FFCobra Craftsman
Joined
·
1,595 Posts
I rec'd 2 sizes in my kit. One was about 1/2" and the other was about 1/4" in diameter. I would check Home Depot though. They have some that are black nylon. Light, cheap and won't rust.
Paul
 

·
Sr FFR builder
Joined
·
5,565 Posts
Kobrak,

The clamps that FFR gives you don't fit standard brake lines too well. They are too big. I would up buying line clamps from summit:



They are better made and fit snug.

HTH,
 

·
Premium Member
Joined
·
6,654 Posts
Home Depot. Electrical section. All sizes, no waiting!

HTH!!
 

·
Premium Member
Joined
·
2,332 Posts
NAPA has a nice type. 5 for $1.39.

-SGC
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top