Factory Five Racing Forum banner
1 - 2 of 2 Posts

·
FFCobra Fanatic
Joined
·
360 Posts
Discussion Starter · #1 ·
I have gotten three of the roll pins out of the shift lugs, but fot the life of me, I cant seem to get the one on the shift selector finger to budge, anyone have suggestions for getting these things out. I considered drilling it out, but would have to remove the extension housing to keep the inside clean of shavings. Also, is there a gasket or anything needed between the tranny and extension housing.

Thanks in advance for the suggestions.

Bret
 

·
Premium Member
Joined
·
9,134 Posts
Hi Bret,
Call me right now @ 781-248-8946
Mike
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top