Factory Five Racing Forum banner
1 - 6 of 6 Posts

· Senior Member
Joined
·
6,544 Posts
Discussion Starter · #1 ·
I received my order from Mark Reynolds / Breeze Automotive yesterday.

I ordered all the miscellaneous nuts and bolts, a fuel filler neck, the two steering shafts (Upper and intermediate), the offset steering rack mounts, and brake pieces/parts. I also ordered a Vortech 351W Alternator bracket.

First, Mark was SUPER cool on the phone.

Second, He went over my list of stuff, and told me what I DIDN'T need or was OVER ordering. He also asked if he could backorder the 351W / Vortech mount. (Key there is that he asked, even though he could have told.) Very cool of him.

Third, I received an e-mail with the UPS # in it, and it was delivered as promised.

Flawless performance and really, really nice parts.

Not only that, but it was obvious that the items were all individually hand picked, checked off the invoice, and very carefully packed. It looked like I packed my stuff, for myself, it was that well done. NO half ass job there!

Thanks Mark! I'm a happy customer!

Anyone thinking about using Breeze Automotive, they definitely get a 10 out of 10 in my book.

:D :D :D :D :D (How about 5 smileys out of 5?)

Regards,

Bill (Ozona)

[ May 31, 2002, 01:46 PM: Message edited by: Ozona ]
 

· Super Moderator
Joined
·
29,344 Posts
I, too, have ordered several parts from Mark. Same great personal service and exceptional quality.

Mark gets a "10" rating from me.

-Keith
 

· Senior Member
Joined
·
6,544 Posts
Discussion Starter · #4 ·
Keith, based on what you're putting in that FFR of yours you had better call the Air Force and make sure you have a permit for that thing.

Dude, you are my HERO! :D
 

· Super Moderator
Joined
·
29,344 Posts
Thanks Ozona

I can't wait to get my IRS unit. Mid July. I still have to get the 8.8 center section. I'm going with an aluminum center section, polished to look cool, and 3.73 gears. This car should be way fast.

Daryl at Precision Brakes has been very helpful. So far, I would give him a 10 also. He asked me a dozen questions in order to properly setup the IRS. We are going with 850# springs, and a race version sway bar.

13" cross-drilled and slotted vented rotors and 4-piston Wilwood calipers.

This car will be an awesome road racer, but way stiff for the street. Hope to have it up and running by next summer.

-Keith
 

· Registered
Joined
·
2,758 Posts
Mark Reynolds is a class act and the parts he sells are top notch. A+++++

[ June 01, 2002, 03:31 AM: Message edited by: teamfour ]
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top