Factory Five Racing Forum banner

Machining TKO500 , whats the deal

989 views 5 replies 5 participants last post by  raceral 
#1 ·
I have read something or the other where something needs to be machined on the tail end to make it fit the trans mount. Anybody got any pictures of what needs to be done
 
#2 ·
Hi Al,
I machine a straight cut from the mount pad to the rear of the seal area.
If you're needing a new Tremec TKO please call me and I can usually ship same day if called early enough.
 
#4 ·
About $100 less than a TKO600, but the 600 has a more useful 1st gear (2.87 vs 3.27) and either a .82 or .64 5th gear. My TCET5008 TKO600 (.64 OD) does 2000rpm at 70mph
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top