Factory Five Racing Forum banner

1 - 5 of 5 Posts

·
Premium Member
Joined
·
1,205 Posts
Discussion Starter #1
Anyone got a nice picture of their license plate wiring - I'm running low on imagination!
 

·
Senior Member
Joined
·
8,350 Posts
I ran mine through the bottom of the trunk floor alum. by the seat belt harness mounts, then ran it between the trunk lid and lid alum., drilled a hole in the alum. near the light and fished a wire in through the hole and pulled the wires from the harness mounts. Left some slack and used small diameter wire loom to show in the trunk. May be better ways, but that worked for me. LOL.
 

·
Registered
Joined
·
1,407 Posts
I went to the hardware store and found a nice-looking piece of black 1/4" i.d. tubing, then used that as a wire loom to go up behind the roll bar and across the trunk hinge tube. Looped it out into the bottom of the trunk aluminum, through a rubber grommet and up to the light. Looks like it was planned....

All the best,
Tag
 
1 - 5 of 5 Posts
Top