Factory Five Racing Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
416 Posts
Discussion Starter · #1 ·
Because of where the pump had to be relocated to and suggestions on here I need to lengthen my PS hose. Well I tried NAPA along with a few other places who can do crimping on hydraulic hoses. They all say they can't do PS hoses. What is so different about a PS hose vs a regular hydraulic hose and where else should I look to get it done?
Thanks in advance
 

·
FFCobra Craftsman
Joined
·
1,626 Posts
Try some of the smaller older parts houses that have the machines. I have had several PS hoses built over the years.
 

·
Premium Member
Joined
·
375 Posts
Try these people. I have this equipment and can make anything.

Tubes & Hoses Of Houston
6529 Dixie Drive, Houston, TX 77087
(713) 644-7235

Tom
 

·
Senior Member
Joined
·
2,990 Posts
I go to Hoseman but then I am pretty close to their store. Below is a link to their web site.

http://www.hose-man.com
 

·
Senior Member
Joined
·
1,073 Posts
My local NAPA did mine. Most can. I would try another NAPA.
 
1 - 6 of 6 Posts
Top