Factory Five Racing Forum banner
1 - 9 of 9 Posts

·
Mid Ohio Loopster
Joined
·
1,980 Posts
Discussion Starter · #1 ·
Bellhousing came out of a Mustang. Has been clearanced for the Mustang long tube headers and a long throw clutch fork. Bolt pattern for a Tremec 3550. Can use either a 157 or 164 tooth flywheel.

$150 plus shipping
 

·
Mid Ohio Loopster
Joined
·
1,980 Posts
Discussion Starter · #3 ·
Steel Bellhousing and blockplate. Blockplate is around 1/8 thick. I know that this was used in a 'stang that was run at a dragstrip. As heavy as this is made, it should contain anything that should happen inside it.

Scott
 

·
Mid Ohio Loopster
Joined
·
1,980 Posts
Discussion Starter · #4 ·
Make me a offer. I'd like to get this out of the garage. I'm sure this is classified as a scattershield.

Scott
 

·
Registered
Joined
·
4,875 Posts
Darn Scott,
Wish it fit a T5, I'd jump on it in a minute! Can they be adapted?

Bob
 

·
Mid Ohio Loopster
Joined
·
1,980 Posts
Discussion Starter · #7 ·
Rod,

Still available. Sent you a pm.

Scott
 

·
Mid Ohio Loopster
Joined
·
1,980 Posts
Discussion Starter · #9 ·
Sold Pending payment at this point.

Scott
 
1 - 9 of 9 Posts
Top