Factory Five Racing Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
837 Posts
Discussion Starter · #1 ·
What is the easiest way to remove the rubber bushings from the IRS knuckles?
 

· Registered
Joined
·
837 Posts
Discussion Starter · #3 ·
thank you
 

· Registered
Joined
·
837 Posts
Discussion Starter · #4 ·
Worked well for the first set of spindles bad the all thread did not last. Will need to get another for the 2nd set
 

· Registered
Joined
·
837 Posts
Discussion Starter · #7 ·
OK, this is just ridiculous. What is better than buying and new press....Borrowing one to put in my garage.

So after maybe 5 min to determine the height to set the platform and lining up the make shift push rod etc. It took another 45 sec to press out the first bushing! The 2nd and third took even less time!

The tool from the FFR - (link above) is kinda cool, but Oh My Goodness!

Stephen Price - Thank you
 

· Registered
Joined
·
837 Posts
Discussion Starter · #10 ·
That looks great JJ, except we were removing the bushings to install new spherical bearings
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top