Factory Five Racing Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
I looked through the archive, but didn’t see a switch like mine. I have the FFR chassis wire harness for my MK4 roadster. When I turn the key to on I can hear the fuel pump relay and I have power to the coil, but no signal to the starter. Starter works fine with a remote switch. I’ve checked to make sure that the clutch safety switch is not depressed and have even jumped the terminals to bypass it entirely. Here is a picture of my switch. It does not match the one in the wiring manual. I’m guessing I’ve got the starter wire on the wrong post
Finger Electrical wiring Cable Audio equipment Gas
 

· Registered
Joined
·
5 Posts
Discussion Starter · #9 ·
I went back through everything this evening. Everything checked out for continuity and the switch tested ok as well. Made a new jumper wire for the clutch safety and starter worked off the key. Put the safety back in with the wires on the back spades as the book shows and nothing. Put them on the front spades and starter works when the plunger is out (pedal pressed down) and not when the pedal is up. I’m happy. Now it’s time to work on the rear brake lines and parking brake cables. Many thanks to all for the replies.
 
1 - 2 of 2 Posts
Top