Factory Five Racing Forum banner

1 - 1 of 1 Posts

620 Posts
Discussion Starter #1
Hello everyone.

To address some clearance issues, I've changed air cleaners from a thin (1 3/4 inch) oval to a 14 x 3 inch round on my Ford x302 crate motor. I was adjusting the idle and noticed that I have close the blades, and there was a little gas "puddling" on the blades and little spits of fuel being thrown out of the throttle body. I never noticed it before, but was able to adjust the screws with the air cleaner on before.

Anything to be concerned about?

1 - 1 of 1 Posts