Factory Five Racing Forum banner
21 - 21 of 21 Posts

·
Registered
Joined
·
6,060 Posts
Sal,

Did you get this figured out? I did the same stupid thing. I was able to remove the lower arm but could not separate the spindle from the upper arm.

-Steve

View attachment 367878
10+ year old thread. Forum member you're asking about: Last seen Sep 2, 2016. Don't think you're going to get an answer from him...

These many years later, yes the arms are marked backwards for a Roadster. Multiple ways to get that ball joint stud out of the UCA. Some will damage the boot, e.g. a pickle fork. I'd try rapping on the side of the spindle next to the stud with a hammer. Should pop it loose.
 
21 - 21 of 21 Posts
Top