Factory Five Racing Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
111 Posts
Discussion Starter #1
I have a 429 with a Toploader behind it. I was thinking of using a McLeod Hydraulic throw out. I was wondering if the 5.0 pedal box will work with this set up and how? If so, what master cylinder would you recommend?


[ August 20, 2002, 12:47 PM: Message edited by: Hawkeye ]
 

·
Rip Snortin Post Maniac
Joined
·
1,044 Posts
I think it would take a lot of custom work to use the Mustang pedal box with a hydraulic clutch. Have you talked to anyone else about a hydraulic throw out bearing? Joe Smith had one on his car and got tired of replacing it. It seems that the heat from the big block plays hell on the throw out bearing seals. Not an easy replacement job either. He pretty much talked me out of using one in my build.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top