Factory Five Racing Forum banner

1 - 4 of 4 Posts

·
FFCobra Fanatic
Joined
·
3,884 Posts
Discussion Starter #1
One of the copper strips is melted on my donor pod, can I just lay some solder between or just solder a wire? Thanks-Bill
 

·
Registered
Joined
·
79 Posts
You should be able to carefully clean the copper strip and solder a short piece of wire to bridge the gap. Use as little heat as possible and work quickly to avoid melting the plastic.

DAve T.
 

·
FFCobra Craftsman
Joined
·
2,733 Posts
Or... E-mail me your address and I can send u a 87
pod or a 90 pod that I did not use. I would be happy to give them away!
Bill
 
1 - 4 of 4 Posts
Top