Factory Five Racing Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
11,825 Posts
Discussion Starter #1
i need to pull the enigine out because i forgot the block plate between the tranny and engine (duh)

nothing is hooked up except the clutch cable. it is very tight, and i don't see any type of adjusting knob. i tired to pull the clutch pedal "up" all the way but the cable is still tight. how do i get it off?
 

·
Senior Charter Member
Joined
·
390 Posts
Stick a pry bar in the bell housing and pry the release fork forward just a bit and unhook the cable from it.
 

·
Registered
Joined
·
11,825 Posts
Discussion Starter #3
duh thaks dude why didn't i think of that

anyone else want to chime in with more advice, or is that 100% for sure the the only feasible and possible way?
 
1 - 4 of 4 Posts
Top