Factory Five Racing Forum banner
1 - 1 of 1 Posts

·
FFCobra Fanatic
Joined
·
2,510 Posts
To get the hole opening easily just use one of the FFR supplied spacers to make sure a bolt will pass through both openings. You will only need to take out about an eight of an inch or so.
As for the fluid tank it will not sit even and opening the holes will not change things it will tilt towards the back and leak if you top it off. My guess is that the mount on the GN has a slight angle that the FFR doesn't have also if it sits flat I think you'll run into pushrod clearance issues. That said I'm sure someone out there has been able to sit their's flat and think's I'm nuts.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top